Publications

2013
Bensari M, Bilami A. A new hybrid authentication protocol to secure data communications in mobile networks. In: Modeling Approaches and Algorithms for Advanced Computer Applications. Springer ; 2013. pp. 195-204.
Bendaas I, Naceri F. A new method to minimize the chattering phenomenon in sliding mode control based on intelligent control for induction motor drives. SJEESJEE. 2013;10 :231-246.
Tir Z, Abdessemed R. A new self-tuning fuzzy PD controller of a BDFIG for wind energy conversion. InternationalJournal of Electrical , Electronic Science and EngineeringInternationalJournal of Electrical , Electronic Science and Engineering. 2013;7.
Semaoui S, Hadj-Arab A, Bacha S, Azoui B. The new strategy of energy management for a photovoltaic system without extra intended for remote-housing. Solar Energy, ElsevierSolar Energy, Elsevier. 2013;94 :71-85.
Hadda H. A note on “A heuristic method for two-stage hybrid flow shop with dedicated machines”. Computers & operations researchComputers & Operations Research. 2013;40 :2283.
H. Madani, NASRI L, Ameur MS. Nouveaux réfrigérants : Expérimentation et Modélisation « R116 + R134a, R116 +C2H6 et R116 +C3H8 ».; 2013.
Mebarki G, RAHAL S, Hamza A. Numerical Heat Transfer Enhancement by Flow Control in a Rectangular Horizontal Channel.; 2013.
Mebarki G, RAHAL S, Hamza A. Numerical Heat Transfer Enhancement by Flow Control in a Rectangular Horizontal Channel. International Journal of Materials, Mechanics and ManufacturingInternational Journal of Materials, Mechanics and Manufacturing. 2013;Vol.1 :pp. 171-176.
BERGOUG N, KADID FZ, Abdessemed R. Numerical modelling of the coupling electromagnetic-hydrodynamic equations of an annular MHD pump. Scientific Bulletin, Series CScientific Bulletin, Series C. 2013;75.
Mebarki G, RAHAL S. Numerical simulation and control of two-phase flow with evaporation in a vertical tube submitted to a conjugate heat transfer. Journal of Energy and Power Engineering. In pressJournal of Energy and Power Engineering. In press. 2013.
Kherraf A, Zidani K, Mazouz H, Chelghoum L, Rezoug L. Numerical Simulation of Hot Isostatic Pressing Process for the Manufacture of Parts Used in Biomechanics. Extracted by" 4th ICOME 2013-Virtual Forum. 2013 :1194.
MESMOUDI K, ZITOUNI B, OUTTAS T, BOURNET PE. Numerical Simulation of The Airflow and Temperature Distribution in a Closed Empty Venlo Glasshouse Under Hot and Arid Climate. Acta HorticActa Hortic. 2013;1008 :pp 235-240.Abstract
The thermal behavior of the inside air of a closed Venlo glasshouse without plants was analysed under semi-arid climate conditions. The aim of the study was to investigate to what extent the characteristics of the greenhouse design and outside climatic conditions influence airflow and temperature patterns inside the greenhouse. For the purpose of the present work, a CFD modeling approach was combined with field surveys. The study focuses on the effects of (i) the thermal inertia of the soil, (ii) the movement of the interior air, and (iii) the distribution of the temperature inside the greenhouse. Two contrasted days were considered: a windy overcast day and clear day. From the results, it is concluded that when the greenhouse is fully closed with bare soil, the heat absorbed and stored by the ground during daytime represents a significant heat source which enhances buoyancy forces, the main driving forces of the movement of the air, especially during the night. The temperature of the roof was relatively low and the air temperature distribution inside the greenhouse disclosed a vertical gradient from the roof towards the ground surface due to the movement of the air above the surface of the ground absorbing thermal energy (solar energy). Maximum air velocities inside the greenhouse were observed near the ground surface, while they reached their minimum values in the middle of the greenhouse. Similar results were obtained for the windy overcast day and for the clear day.
HALITIM S, ZITOUNI B, CHAOUKI A. Numerical study of thermal stratification in T-jonction. Liban; 2013.
Houria HS, Bariza Z, Chaouki A. Numerical study of Thermal Stratification in T-Junction. Energy ProcediaEnergy Procedia. 2013;36 :114-119.
Semaoui S, Hadj-Arab A, Bacha S, Azoui B. Optimal sizing of a stand-alone photovoltaic system with energy management in isolated areas.; 2013.
Semaoui S, Hadj-Arab A, Bacha S, Azoui B. Optimal sizing of a stand-alone photovoltaic system with energy management in isolated areas. Energy Procedia, ElsevierEnergy Procedia, Elsevier. 2013;36 :358-368.
Semaoui S, Arab AH, Bacha S, Azoui B. Optimal sizing of a stand-alone photovoltaic system with energy management in isolated areas. Energy ProcediaEnergy Procedia. 2013;36 :358-368.
Louazene ML, Korichi D, Azoui B. Optimization of global solar radiation of tilt angle for solar panels, location: Ouargla, Algeria. Journal of Electrical Engineering : Edition 1Journal of Electrical Engineering : Edition 1. 2013;13 / 2013.
Mohamed H. Optimization of Single-Manufacturer Multiple-Contractors Outsourcing Relationship in Integrated Approach of Production, Maintenance and Quality.; 2013.
Mohamed H, M.Dahane, Kinza MN, N.Rezg. Optimization of Single-Manufacturer Multiple-Contractors Outsourcing Relationship in Integrated Approach of Production, Maintenance and Quality, submitted in IEEE International.; 2013.

Pages