In this paper, numerous experimental tests were carried out to study the behavior of concrete containing glass fibers and confined with glass fiber-reinforced polymer (GFRP). Concrete specimens containing different fiber percentages ( 0.3 wt.%, 0.6 wt.%, 0.9 wt.% or 1.2 wt.%) and with different strengths of concrete (8.5 MPa, 16 MPa and 25 MPa) and different confinement levels (two, four and six layers of GFRP) were used as research parameters. The samples were tested to failure under pure axial compression. The results imply that the confinement effect with GFRP is relatively higher for concrete samples containing glass fiber (GFCC) with a percentage equal to 0.6 wt.%. The theoretical of stress ratios (fcc/fco) estimated by using existing ultimate strength models are found to be close to the experimental results for high strength of GFCC, but not close to the experimental results for low strength of GFCC.

During the last two decades, the attention of researchers has been focused on repairing and retrofitting concrete frames to make them more earthquake-resistant. Two methods have been developed to increase the seismic resistance of previously undamaged structures before they are subjected to an earthquake. The first is through the addition of new structural members, such as steel braces and the second is by selectively strengthening structural elements, for instance through steel caging. Seismic response analysis results have been utilized in multi-story RC frames that were designed without seismic design criteria. This study aims to determine whether the retrofitting technique is effective based on comparisons between steel braces, steel cages, and their combinations. The seismic performance is defined by the seismic code for Algeria RPA 2003 according to the latest recommendations. Static nonlinear analysis was used to compare seismic responses of existing non-ductile reinforced concrete RC frames under a variety of retrofit schemes. The results show that retrofitting with steel caging gives excellent performance in terms of ductility and low shear capacity. The retrofitting with steel bracing increased the shear capacity but led to a severe ductility deficiency. The retrofitting structure combined with steel bracing and steel caging shows good performance in shear capacity and ductility. Using the Zipper system (steel bracing) and V system in combination with steel caging gives similar results to the RPA model.

During the last two decades, the attention of researchers has been focused on repairing and retrofitting concrete frames to make them more earthquake-resistant. Two methods have been developed to increase the seismic resistance of previously undamaged structures before they are subjected to an earthquake. The first is through the addition of new structural members, such as steel braces and the second is by selectively strengthening structural elements, for instance through steel caging. Seismic response analysis results have been utilized in multi-story RC frames that were designed without seismic design criteria. This study aims to determine whether the retrofitting technique is effective based on comparisons between steel braces, steel cages, and their combinations. The seismic performance is defined by the seismic code for Algeria RPA 2003 according to the latest recommendations. Static nonlinear analysis was used to compare seismic responses of existing non-ductile reinforced concrete RC frames under a variety of retrofit schemes. The results show that retrofitting with steel caging gives excellent performance in terms of ductility and low shear capacity. The retrofitting with steel bracing increased the shear capacity but led to a severe ductility deficiency. The retrofitting structure combined with steel bracing and steel caging shows good performance in shear capacity and ductility. Using the Zipper system (steel bracing) and V system in combination with steel caging gives similar results to the RPA model.

Sebkha soils are defined as problem soils located in arid, semi-arid, and coastal areas. Generally, they are fine soil, composed of silt, sand, and clay, which are cemented by different salts (e.g., halite, gypsum, and calcite). In nature, sebkha saline soils are exposed to different drying and wetting (D-W) cycles. However, these cycles have a significant effect on the mechanical behavior of these soils. This study aims to characterize the chemical, mineralogical, and geotechnical properties of sebkha soil using an experimental approach. We focus on the effects of D-W cycles on the unconfined compressive strength (UCS) and salinity of sebkha soils from Ain M’Lila, Algeria. In addition, these D-W cycles were applied to the samples dried in the open air to achieve the targeted water content (water content values of 7%, 11.4%, and 13%). The results obtained show that the UCS increases with decrease in water content and decreases with an increase in the number of D-W cycles. In addition, these cycles affect the salinity of the sebkha soil. Indeed, a significant decrease in soil salinity was recorded with an increase in the number of D-W cycles. Finally, a relationship was found between the salinity of the soil and UCS. The latter decreases with a decrease in soil salinity; this relationship becomes very significant for low water content values of 7% or less.

Sebkha soils are defined as problem soils located in arid, semi-arid, and coastal areas. Generally, they are fine soil, composed of silt, sand, and clay, which are cemented by different salts (e.g., halite, gypsum, and calcite). In nature, sebkha saline soils are exposed to different drying and wetting (D-W) cycles. However, these cycles have a significant effect on the mechanical behavior of these soils. This study aims to characterize the chemical, mineralogical, and geotechnical properties of sebkha soil using an experimental approach. We focus on the effects of D-W cycles on the unconfined compressive strength (UCS) and salinity of sebkha soils from Ain M’Lila, Algeria. In addition, these D-W cycles were applied to the samples dried in the open air to achieve the targeted water content (water content values of 7%, 11.4%, and 13%). The results obtained show that the UCS increases with decrease in water content and decreases with an increase in the number of D-W cycles. In addition, these cycles affect the salinity of the sebkha soil. Indeed, a significant decrease in soil salinity was recorded with an increase in the number of D-W cycles. Finally, a relationship was found between the salinity of the soil and UCS. The latter decreases with a decrease in soil salinity; this relationship becomes very significant for low water content values of 7% or less.

Sebkha soils are defined as problem soils located in arid, semi-arid, and coastal areas. Generally, they are fine soil, composed of silt, sand, and clay, which are cemented by different salts (e.g., halite, gypsum, and calcite). In nature, sebkha saline soils are exposed to different drying and wetting (D-W) cycles. However, these cycles have a significant effect on the mechanical behavior of these soils. This study aims to characterize the chemical, mineralogical, and geotechnical properties of sebkha soil using an experimental approach. We focus on the effects of D-W cycles on the unconfined compressive strength (UCS) and salinity of sebkha soils from Ain M’Lila, Algeria. In addition, these D-W cycles were applied to the samples dried in the open air to achieve the targeted water content (water content values of 7%, 11.4%, and 13%). The results obtained show that the UCS increases with decrease in water content and decreases with an increase in the number of D-W cycles. In addition, these cycles affect the salinity of the sebkha soil. Indeed, a significant decrease in soil salinity was recorded with an increase in the number of D-W cycles. Finally, a relationship was found between the salinity of the soil and UCS. The latter decreases with a decrease in soil salinity; this relationship becomes very significant for low water content values of 7% or less.

External confinement by the GFRP composites offers an actual process for retrofitting glass fibre reinforced concrete columns (GFRC) subject to static or seismic loads. This paper presents an experimental investigation and analytical modelling of the axial compression of confined circular concrete columns of different strengths (8.5, 16, and 25 MPa). Furthermore, the columns contain different percentages of glass fibres (0.3 to 1.2 %), and their confinement is given by GFRP composites of various thicknesses (0.8 to 2.4 mm). The uniaxial compression test on these specimens reveals that the glass fibre percentage and the thickness of the GFRP play a vital role in improving the load-deformation behaviour and crack propagation. Whatever the concrete strength, the ultimate axial strain and stress predicted using the suggested confinement model almost agrees with the available experimental results.

External confinement by the GFRP composites offers an actual process for retrofitting glass fibre reinforced concrete columns (GFRC) subject to static or seismic loads. This paper presents an experimental investigation and analytical modelling of the axial compression of confined circular concrete columns of different strengths (8.5, 16, and 25 MPa). Furthermore, the columns contain different percentages of glass fibres (0.3 to 1.2 %), and their confinement is given by GFRP composites of various thicknesses (0.8 to 2.4 mm). The uniaxial compression test on these specimens reveals that the glass fibre percentage and the thickness of the GFRP play a vital role in improving the load-deformation behaviour and crack propagation. Whatever the concrete strength, the ultimate axial strain and stress predicted using the suggested confinement model almost agrees with the available experimental results.